SPLINT SIZE GUIDE
Splint Size Video
Splint Size Table
The part of the finger or thumb that you need to measure will depend on the joint area you would like the splint to immobilise and provide support, you will need to accurately measure the circumference of this joint.
To do this you will need to complete 6 easy to follow steps below. You will need a pen, paper, scissors, ruler or measuring device.
1. Identify the joint area that requires immobilisation and support; on the thumb it is the IP joint and on a finger, it is either the PIP or DIP joint.
2.Cut out a strip of paper similar to the image below and wrap it around the IP, PIP, or DIP joint area that needs to be measured.
3. Position the strip of paper around the identified joint at its widest point until it fits comfortably; making sure that it is not too tight that it would cause further pain or too slack that it feels like it would slip off. For Trigger finger, or other conditions in the middle of the finger, the paper strip needs to be centred on the PIP joint. For Mallet finger, or other distal finger conditions, the paper strip needs to be centred on the DIP joint. For thumb conditions it needs to be positioned on the IP joint.
4.Mark the piece of paper with a pen at the point it makes a complete circumference measurement of your identified joint, so when you unwrap the piece of paper you have two marks.
5.Straighten out the strip of paper that you used to measure your identified joint and use a ruler or measuring device to measure between the two marks that you made.
6. Consult the splint size table below to identify your required splint size by looking for your measurement next to the corresponding splint size. You will then be able to order the required splint in the drop-down menu in the relevant product listing.
Further help can also be provided by contacting us via the customer service tab.
Please follow the sizing instructions in the splint size guide to identify the required circumference measurement.
Consult the splint size table below to identify your required splint size by looking for your measured circumference measurement next to the corresponding splint size, then order the required splint in the drop-down menu in the relevant product listing.
WEAR
Arthro-Eze splint products can be worn day or night and multiple splints can be worn without limiting the movement of your hands. The splints can be worn over plasters or bandages, you can also wear your Splints in the water while washing your hands or bathing without removing them.
Please contact us if you experience any discomfort or have any concerns or want any help in selecting the correct sized splint. Please monitor your finger or thumb colour and temperature as it may discolour slightly when you first put the splint on. If you have any concerns and would like to try a different size, please contact us, as we provide an exchange service where we can send you a selection of different sizes to to try.
Please note that finger splints are not recommended for children under the age of 4 as they may cause a possible choking hazzard.
CARE
All Arthro-Eze products are hand washable, waterproof, made from biocompatible plastic and are latex free. To clean the splint, use a soft nonabrasive cloth, warm water with a light detergent.
